KiCad 6 STM32 PCB Design Full Tutorial - Phil's Lab #65

What people said

waerhert · 2025-08 · Recommendation

Checking the datasheet is essential, they usually show the “must-have” parts around a chip. Beyond that, good habits are adding decoupling caps close to the pins, keeping ground solid, and following the reference layout. I also learned a lot just by listening to experienced designers explain their choices, like here: [VIDEO]

Read the original HN comment ↗

mlsu · 2024-04 · Recommendation

I'm in embedded also, I started this journey at work doing board bring-up. I wrote drivers mostly, not doing any direct electrical work, but after reading the schematics I thought, "oh wow, so that's how they do schematics professionally," followed by "wait, I can do that!" Before that, I just did a few small things with Arduino. The Youtube channel Phil's Lab has a really good series [1] on PCB design focused on STM32 series chips, that is where I started. I also got a lot of good information in this thread [2] And I got feedback on one of my designs on the PrintedCircuitBoard reddit, which is very active and full of amateur and pro-am PCB designers getting feedback. You can post a schematic or layout and people will leave high quality critiques. For vendors, I have had 2 runs made with JLCPCB (with each run having flaws; some bad, and some not too bad; my board is fairly complex/ambitious so that's part of it). I have heard PCBWay is similarly cheap and good. No quality issues but I've kept traces, spacing, and components on the larger side. I'm not good at PCB design but am having a blast with it. [1] [VIDEO] [2] [LINK] [3] [LINK]

Read the original HN comment ↗

LeifCarrotson · 2022-10 · Recommendation

A few months ago, you would have been on Kicad 6 (assuming you didn't pull some ancient 5.0 release from your distro), which I've found to have a great UI. Like all EDA software, the UI is optimized for power users, and therefore has some quirks and a learning curve for the hotkeys, but I would not say that Kicad is phenomenally bad. Work your way through one tutorial (eg. this recent one: [VIDEO] ) and make a quick-reference note for shortcuts, and you can probably be off to the races.

Read the original HN comment ↗